How to Program 2019 Ford Explorer Garage Door Opener
Are you looking to program your 2019 Ford Explorer’s garage door opener? If so, you’ve come to the right place. Programming the garage door opener in your 2019 Ford Explorer is a straightforward process that can be completed in just a few simple steps. In this article, we’ll guide you through the process, ensuring that you can easily program your garage door opener and enjoy the convenience of hands-free access to your garage.
Step 1: Gather the Necessary Tools
Before you begin programming your 2019 Ford Explorer’s garage door opener, make sure you have the following tools on hand:
– The garage door opener remote control
– A flathead screwdriver
Step 2: Locate the Programming Button
Next, locate the programming button on your garage door opener. This button is typically located on the side of the garage door opener unit and is marked with a symbol that resembles a key or a remote control.
Step 3: Turn Off the Power to the Opener
To prevent any interference during the programming process, it’s important to turn off the power to the garage door opener. You can do this by unplugging the unit from the electrical outlet or by flipping the circuit breaker that controls the garage door opener.
Step 4: Press and Hold the Programming Button
With the power turned off, press and hold the programming button on the garage door opener unit for about 5 seconds. You should see a light or indicator on the unit turn on, indicating that the programming mode is activated.
Step 5: Press the Learn Button on the Remote Control
While still holding the programming button on the garage door opener, press the learn button on the remote control. The learn button is typically located on the back of the remote control and may be marked with a small arrow or a “learn” symbol.
Step 6: Release the Programming Button
After pressing the learn button on the remote control, release the programming button on the garage door opener unit. If the programming was successful, you should hear a chime or see a light on the remote control indicating that the code has been learned.
Step 7: Test the Garage Door Opener
To ensure that the programming was successful, test the garage door opener by pressing the button on the remote control. The garage door should open and close as expected.
Step 8: Reconnect the Power to the Opener
Once you have confirmed that the garage door opener is functioning correctly, reconnect the power to the unit by plugging it back into the electrical outlet or flipping the circuit breaker.
Congratulations! You have successfully programmed the garage door opener in your 2019 Ford Explorer. With your new remote control, you can now enjoy the convenience of opening and closing your garage door with just a press of a button.
